Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Make small rudder corrections against a point at the far end to hold the centreline.
What happened: During the ground roll you drifted 8.7 m off the runway centreline.
Watch for: Watch runway alignment against the centreline, correcting with small rudder inputs.
See Departure Roll
Arrival
Use small rudder inputs against a point at the far end of the runway to hold the centreline during rollout.
What happened: During the rollout the aircraft drifted 10 m off the centreline.
Watch for: Runway centreline marks: hold the aircraft tracking straight down the centreline through rollout
See Arrival Rollout
Ground control varies with speed, full authority at walking pace, progressively reducing as groundspeed rises. The aircraft becomes twitchy at any speed, every small pedal input swings the nose, which can encourage large-amplitude leg inputs that no real aircraft would accept.
Read more in How to Taxi AnywhereStart to finish · 20 stages, 15 in the score
The approach before the go-around was abandoned. Its marks are shown, but only the approach that landed counts.
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
The threshold, the flare and the hold-off. The approach that led to it is the stabilisation gates below.
Two stabilised approach gates, each with seven checks, where the approach path is 1,000 ft and 500 ft above the runway. They are the approach's score: the checks passed out of the checks that ran.
The approach, gate by gate
Side view — the last 1,803 m of the approach.
Plan view — the first 1,803 m of the 3,090 m runway, to the same scale as the side view.
Touched down 587 m past the threshold — beyond the full-score zone. The arrival was smooth.
The rest of the report
The Airbus A320-ceo taxied from the parking area to runway 16 at LSZH Zürich Airport, a movement that required 13 minutes and covered 4 nm.
Take-off was executed on runway 16, with a ground roll of 2,092 m representing 57 % of the available runway. Rotation was achieved at 159 kt. Local conditions were 14 °C temperature, wind 1 kt from 359°, with a 0 kt cross-wind component and a 1 kt tail-wind.
Climb began overhead Opfikon, lifting the aircraft from 2,352 ft asl to 32,991 ft asl, an altitude gain of 30,639 ft in 19 minutes while traversing 127 nm.
The first cruise segment started 1 mile north-west of Crassier and continued for 127 minutes, covering a distance of 1,010 nm at level flight.
Descent commenced 19 nm south of GMMB Ben Slimane Airport, descending from 32,682 ft asl to 3,415 ft asl, a loss of 29,266 ft in 20 minutes and spanning 127 nm.
A brief cruise phase followed, beginning 16 nm west of GMMX Menara Airport and lasting 3 minutes for a distance of 10 nm.
The next descent started 8 nm west of GMMX Menara, dropping from 3,208 ft asl to 2,610 ft asl, a reduction of 598 ft in 2 minutes over 4 nm.
The first final-approach to runway 10 at GMMX Menara Airport reduced altitude from 1,078 ft agl to 53 ft agl in 91 seconds; the approach was recorded as having met the stabilisation gates.
A go-around was initiated on runway 10 at an altitude of 13 ft agl, after which the aircraft re-entered the approach sequence.
A second final-approach to runway 10 descended from 1,232 ft agl to 46 ft agl in 96 seconds, again satisfying the stabilisation gate criteria.
Landing on runway 10 was performed with a threshold speed of 136 kt. Touchdown occurred 167 m beyond the touchdown zone at 129 kt, with a vertical speed of minus 221 fpm and a lateral deviation of 4.1 m from the centreline. Local weather reported 29 °C temperature, wind 3 kt from 310°, a 2 kt cross-wind and a 2 kt tail-wind. The total landing roll measured 1,718 m, equivalent to 56 % of the runway length.
Runway rollout alignment was noted as slightly off centreline by 10.3 m.
The aircraft taxied from the runway to the parking area in 1 minute, covering less than 1 nm.
In total, the flight covered 1,330 nm, required 194 minutes of airborne time, and consumed 8,147 kg of fuel.
Scroll or drag the slider to zoom · double-click to reset · hover for values