Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Apply small rudder corrections to track the centreline against a point at the far end of the runway.
What happened: The takeoff roll drifted 298 ft off the centreline, and a heading variation of -14° usually follows into the initial climb.
Watch for: Heading indicator: wings-level runway heading held through the climb
Arrival
Reduce power on approach to bring threshold speed back to 64 kt.
What happened: The aircraft crossed the threshold at 82 kt, 18 kt above the 64 kt target, then ballooned in the flare as the excess speed met the flare's back pressure. Crossing fast and ballooning like this usually carries the touchdown long.
Watch for: Airspeed indicator: 64 kt at the threshold
High on final, the pilot dives to the aim point, converting altitude directly into airspeed, and arrives on-glideslope but 15 knots fast. The vertical profile looks fine; the speed trace does not. It is one of the reasons the stabilised-approach concept - configured, on speed, on path by a gate, commonly 1,000 ft in IMC and 500 ft in VMC - checks speed and path together, and why the tolerances airlines use are asymmetric, typically allowing more on the fast side than the slow, because slow kills faster than fast.
Read more in VRef ExplainedStart to finish · 12 stages, 8 in the score
The approach before the go-around was abandoned. Its marks are shown, but only the approach that landed counts.
Events
Events
Events
Events
Taxi out
The roll
A clean takeoff
Rotated at 68 kt against the 70 kt rotate speed.
Rotated on speed at a steady rate, and the climb attitude held. This is the takeoff to repeat: the same speed check, the same pull, the same attitude.
Liftoff and climb
Plan view the roll down the 2,473 ft runway.
Rolled from 375 ft in, drifted left of the centreline, 295 ft at the widest, and lifted off 298 ft left. Airborne 52 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way.
Side view from the start of the roll to 0 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The figure at liftoff is the pitch then.
The final from 4 nm.
Profile height against the 3° glideslope, with its 2° band in green.
On the glideslope from 0.5 nm, where the final began, to 0.3 nm, then low to the threshold (up to 100 ft under).
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 1,000 ft past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 860 ft left of the centreline at 0.5 nm.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 32 kt fast at the 1,000 ft gate, closing to 19 at 500 ft and 10 at the threshold.
Inside the speed band all the way, between −0 kt and +14 kt on the approach speed of 64 kt.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
The flare strayed well off the target profile
Crossing the threshold 18 kt above target, the flare ballooned 30 ft agl back up from 0 ft agl above the runway, 1,523 ft in. Touchdown was 3,554 ft past the threshold. Hold the attitude and let it settle rather than pushing - that excess speed is what turns a normal flare into a balloon, so the fix is on the approach, not in the flare.
Touchdown
Rollout
Side view — the last 5,000 ft of the approach.
Began the flare at 25 ft, 1,447 ft before the threshold; crossed the threshold at 29 ft, 21 ft below the 50 ft target; ballooned 30 ft from 0 ft. Touched down 3,554 ft in, 2,554 ft past the ideal 1,000 ft.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 5,000 ft across. The dashed line is the ideal, 50 ft over the threshold and down 1,000 ft in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
From the flare the descent stopped and turned into a climb of 440 fpm before coming down at 310 fpm to touch. The pitch barely changed. Into the flare at 64 kt, on the 64 kt approach speed, and 69 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the first 5,000 ft of the 5,036 ft runway, to the same scale as the side view.
Touched down 84 ft left of the centreline and drifted to 95 ft left on the rollout. Little crosswind (1 kt): nothing to correct for. Touched down with the nose 2° right of the track, wings level.
Wind 270° at 2 kt · 1 kt head · 1 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
Touched down 3,554 ft past the threshold — beyond the full-score zone. The 306 fpm arrival was firm.
The rest of the report
Departing from Kenmore Air Harbor LLC Seaplane Base, the DHC-2 Beaver began its takeoff roll on runway 21, utilizing 1,605 feet of the available 2,470 feet. The aircraft lifted off at a speed of 75 knots, clearing the ground with a minimal margin. Local weather conditions were favorable, with a temperature of 60°F and a gentle headwind of 1 knot.
As the aircraft transitioned into the enroute climb phase, it began to ascend from an initial altitude of 615 feet above sea level to 978 feet, a gain of 362 feet in just one minute. This climb was achieved while covering a distance of 3 nautical miles. Following the climb, the aircraft entered a level cruise phase, maintaining a steady altitude for 3 minutes as it traversed 6 nautical miles. The final approach to runway 18W at Seattle Seaplanes Seaplane Base was initiated from the northeast, with the aircraft descending from an altitude of 68 feet above ground level.
The approach was interrupted by a go-around, with the aircraft lifting off from 19 feet above ground level. Upon re-initiating the approach, the DHC-2 Beaver landed on runway 18W, which measured 5,040 feet in length. The touchdown speed of 69 knots was slightly above the target, while the touchdown rate of -177 feet per minute was satisfactory. However, the touchdown point was 478 feet beyond the designated touchdown zone, and the runway touchdown position was significantly misaligned by 84 feet from the centerline. The total landing distance of 2,568 feet, accounting for 51% of the available runway, was notable, as was the runway rollout alignment, which was misaligned by 95 feet from the centerline. The total flight distance of 10 nautical miles was achieved in 9 minutes, with the aircraft consuming 21 pounds of fuel.
Scroll or drag the slider to zoom · double-click to reset · hover for values