Events
Events
Events
Events
Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Ease the back pressure on the yoke after rotation so the pitch change is smoother and g force stays lower.
What happened: During the initial climb the average g force reached 1.5 g, a high value for that phase.
Watch for: G meter: smooth, steady value in the normal climb band
Arrival
Reduce power earlier on final to bring threshold speed back to 107 kt.
What happened: You crossed the threshold at 123 kt against a target of 107 kt, and touchdown ended up well past the normal point. Carrying excess threshold speed usually carries the touchdown long as the aircraft floats before settling.
Watch for: Airspeed indicator, targeting 107 kt at the threshold.
The rudder input is a changing profile through the roll rather than one that is held. So the demand on your right foot starts large at power application, eases as speed builds and the rudder gains authority, then jumps again at rotation.
Read more in Improve Your Take-OffsStart to finish · 17 stages, 14 in the score
Events
Events
Events
Events
Events
Events
Events
Events
Events
Taxi out
The roll
Liftoff pitch close to a tail strike
The wheels left at 8.9°, at or past this aircraft's 8° tail strike.
The tail can only touch while the main wheels are still on the runway, so the margin that matters is the one at liftoff. Rotate at the rotate speed, at the normal rate, and let the aircraft fly itself off at its own attitude: keep the pull going towards the climb attitude only once the wheels have left. Rotating early, or pulling faster than the aircraft can lift off, is what eats the margin.
Liftoff and climb
Plan view the roll down the 3,284 m runway.
Rolled from 54 m in, drifted left of the centreline, 6.5 m at the widest, and lifted off 5.7 m left. Airborne 31 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way.
Side view from the start of the roll to 296 ft.
Reached 35 ft with 2,106 m of runway left.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length. The dark stretch of the roll is the run with the nose up and the wheels still on, with its length and time under the runway.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The dashed green line is the speed to rotate at for this aircraft at its weight, and the green dot is where the nose started to come up. The grey band is the run between the nose coming up and the wheels leaving the runway. The figures at liftoff are the pitch then and how fast the nose came up, in degrees a second. The rotation detail below draws the rotation against the rates for this aircraft and its tail-strike pitch, where the slope reads properly. The grey dashed line across the pitch is the attitude held from 35 ft to the end: a nose held steady is a climb speed that holds, and the airspeed trace sits directly above it to compare.
Rotation detail the pitch over the seconds from rotation to 35 ft, where the slope reads properly.
The pitch over the seconds from the nose starting to come up to 35 ft, stretched so the slope reads properly. The green dot is where the nose started up, the grey band runs to the wheels leaving, and the figures at liftoff are the pitch then and how fast the nose came up. The two dashed green lines rising from the rotation point are 2.5 to 4.2° a second, the middle half of rotation rates flown by other ATR 72 pilots over the last 180 days (40 takeoffs); the grey pair are 2 to 3° a second, the rates airliners are rotated at. A trace steeper than both green lines is a faster rotation than most, one shallower than both a slower one. Each line runs from the rotation to the liftoff, so where it ends is the pitch the nose would have reached by the time the wheels left at that rate; a line that reaches the tail strike first stops on it. The red dashed line is 8°, the pitch at which this aircraft's tail touches the runway with the wheels still on it, drawn from rotation to liftoff only: once the wheels leave, every foot climbed adds tail clearance.
Right-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 1.5 nm out at 154 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Early: turned crosswind before the end of the runway, at 996 ft.
Upwind (departure). Climb straight ahead on the extended centreline. Don't turn early. A curved departure leg makes every subsequent leg unrepeatable.
Read more in Pattern WorkHigh on downwind: 1,145 ft against 1,000 ft, 145 ft above.
Downwind. Parallel to the runway, opposite the landing direction, at pattern altitude and roughly 90 kt. The single most important moment of the entire circuit is the point abeam your intended touchdown point. Power back (around 1,700 RPM in a 172 works as a starting value to calibrate), first stage of flap, pre-landing flow, and re-trim. Everything from abeam to touchdown is one continuous energy problem. Arrive at the abeam point high or fast and you'll pay for it ninety seconds later in the flare, which is why analysing only the touchdown so often misdiagnoses the fault.
Read more in Pattern WorkLate: turned base with the threshold 22° behind, against 45°.
The stopwatch. From abeam the threshold, fly roughly 30 to 45 seconds before turning base, in nil wind at 172 speeds. Treat that as a starting value and calibrate it. If your finals keep coming out at 400 ft instead of 500, add a few seconds. Then adjust for wind, roughly a second per knot of headwind on final (a headwind on final is a tailwind on downwind, carrying you further from the field per second).
Read more in Pattern WorkGood: full marks on the turn.
The final from 4 nm.
Profile height against the 3° glideslope, with its 1° band in green.
Inside the glideslope band from 4 nm to the threshold, never more than 260 ft below the slope.
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 305 m past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Inside the 1° band from 4 nm to 3.0 nm, then drifted 115 m right between 3.0 and 2.3 nm, then back inside it from 2.3 to 0.4 nm, then 13 m left of it from 0.4 nm to the threshold.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 27 kt fast at the 1,000 ft gate, closing to 16 at 500 ft and 10 at the threshold.
Outside the speed band 3 times; furthest +28 kt at 3.4 nm.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
The flare tracked the target profile exactly
Crossing the threshold 17 kt above target, the aircraft floated down the runway before touching. Touchdown was 802 m past the threshold. The flare cannot burn off excess energy - fix the approach speed and the float goes with it.
Touchdown
Rollout
Taxi in
Side view — the last 1,524 m of the approach.
Crossed the threshold at 54 ft, close to the 50 ft target; began the flare at 32 ft. Touched down 802 m in, 497 m past the ideal 305 m.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 1,524 m across. The dashed line is the ideal, 50 ft over the threshold and down 305 m in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 340 fpm at the flare to 70 fpm at 10 ft, then back up to 240 fpm at touchdown. The pitch barely changed. Into the flare at 122 kt, 15 kt over the 107 kt approach speed, and 110 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the first 1,524 m of the 3,284 m runway, to the same scale as the side view.
Touched down 3.1 m left of the centreline and drifted to 8.1 m left on the rollout, back to 2.3 m left by the end. 4 kt across from the left, which takes about 2° of crab to hold the centreline at 110 kt. Touched down with the nose 3° into wind, 2.1° of bank.
Wind 001° at 5 kt · 2 kt head · 4 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
Touched down 802 m past the threshold — beyond the full-score zone. The arrival was smooth.
The stop — touchdown to taxi speed.
From 111 kt at touchdown to taxi speed (30 kt) in 12 s, an average deceleration of 0.36 g.
Your ground speed from the moment the wheels touched until you were down to taxi speed, against the distance rolled. A steep line is hard braking, a shallow one a long, gentle roll. For scale, an airliner's lowest autobrake setting decelerates at about 0.15 g, a medium one about 0.3 g. Shown for reading; not marked.
The rest of the report
The ATR-72 departed from runway 05R at NZAA Auckland International Airport. Take-off was achieved after a roll of 1,020 m (31 % of the runway) with rotation at 115 kt. The local weather was 34 °C, wind 5 kt from 001°, giving a 5 kt cross-wind component and a 2 kt head-wind component.
Initial climb to 400 ft agl took 8 seconds, averaging 1,799 fpm and reaching 125 kt at the top of the climb. The aircraft then entered a right-hand circuit for runway 05R. The downwind leg was 6 nm and lasted 130 seconds at 1,140 ft agl; the base leg was less than 1 nm and lasted 15 seconds.
On final approach the aircraft descended from 1,001 ft agl to -5 ft agl in 111 seconds. Stabilisation checks at 1,000 ft and 500 ft above the runway were all met: gear down, landing flap, sink rate, glideslope, centreline, speed, and wings level. At 1,040 ft agl the aircraft was in final flap position 2 and was flying 140 kt.
Landing was on runway 05R (runway length 3,284 m). The threshold speed was 124 kt, well above target. The flare was described as perfect; the aircraft floated before touchdown. Touchdown occurred 375 m beyond the touchdown zone at a speed of 110 kt, a little fast, with a rate of -240 fpm. The touchdown point was 3.1 m off the centreline but runway rollout alignment was very good. No bounce occurred. Total landing distance was 1,126 m (34 % of the runway).
After landing the aircraft taxied to parking in less than 1 minute, covering less than 1 nm. The total flight was 17 nm, lasted 9 minutes and used 112 kg of fuel. The landing weather was 32 °C, wind 5 kt from 001°, with a 5 kt cross-wind and a 2 kt head-wind component.
Scroll or drag the slider to zoom · double-click to reset · hover for values