Events
Events
MY FS FLIGHTS
Flight Score
Departure
Ease the nose up sooner to lift off at 58 kt instead of letting speed build on the ground.
What happened: The aircraft lifted off at 87 kt, 29 kt above the target liftoff speed.
Watch for: Airspeed indicator: 58 kt at liftoff
See Departure Roll
A typical trainer rotates in the mid-50s of knots - a 172 at around 55 KIAS, climbing out at a Vy in the low 70s, though check your own POH rather than memorising Cessna's numbers - and the transferable rule is that Vr sits just above the stall speed in takeoff configuration. Rotate early because "it felt ready" and the aircraft lifts off inside ground effect, where induced drag is reduced, then climbs out of it into more drag. On a marginal-performance day the result is an aircraft that lifts off and then refuses to climb, sagging back towards the runway.
Read more in Improve Your Take-OffsStart to finish · 3 stages, 3 in the score
Events
Events
Taxi out
The roll
Liftoff and climb
Plan view the roll down the 1,636 m runway.
Rolled from 639 m in, drifted 3.5 m left of the centreline and was back on it to lift off. Airborne 52 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length.
Side view from the start of the roll to 400 ft.
Reached 35 ft with 620 m of runway left; then climbing at 950 fpm on average to 400 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The figure at liftoff is the pitch then.
The rest of the report
Scroll or drag the slider to zoom · double-click to reset · hover for values