Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Make small rudder corrections against a point at the far end to hold the centreline.
What happened: During the ground roll you drifted 10 m off the runway centreline.
Watch for: Watch runway alignment against the centreline, correcting with small rudder inputs.
See Departure Roll
Arrival
Track the centreline through touchdown using small rudder corrections against a point at the far end of the runway.
What happened: The aircraft touched down off the centreline at 9.6 m, and drifting off centreline at touchdown usually carries through into the rollout, as it did here with alignment reaching 43 m.
Watch for: Watch runway centreline position, keeping deviation inside the limit through touchdown and rollout.
Ground control varies with speed, full authority at walking pace, progressively reducing as groundspeed rises. The aircraft becomes twitchy at any speed, every small pedal input swings the nose, which can encourage large-amplitude leg inputs that no real aircraft would accept.
Read more in How to Taxi AnywhereStart to finish · 17 stages, 14 in the score
Events
Events
Events
Events
Events
Taxi out
The roll
A clean takeoff
Rotated at 86 kt against the 83 kt rotate speed, then held 7.0° from 35 ft, within 4.3° top to bottom.
Rotated on speed at a steady rate, and the climb attitude held. This is the takeoff to repeat: the same speed check, the same pull, the same attitude.
Liftoff and climb
Plan view the roll down the 3,050 m runway.
Rolled from 223 m in, drifted right of the centreline, 10 m at the widest, and lifted off 3.7 m right. Airborne 43 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way.
Side view from the start of the roll to 76 ft.
Reached 35 ft with 1,459 m of runway left.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The figure at liftoff is the pitch then. The grey dashed line across the pitch is the attitude held from 35 ft to the end: a nose held steady is a climb speed that holds, and the airspeed trace sits directly above it to compare.
Left-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 1.2 nm out at 116 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Early: turned crosswind at 671 ft. US guidance is within 300 ft of circuit height, 700 ft here, so the climb ends on downwind.
Crosswind. Turn 90 degrees when you're within about 300 ft of pattern altitude, which at a standard field means roughly 700 ft AGL, or two-thirds of the way up. That rule exists for a reason worth knowing. It means you finish the climb and level off on downwind, wings level, rather than trying to capture an altitude mid-turn. If you turn crosswind at pattern altitude instead, you arrive on downwind still cleaning up, and the abeam point catches you unconfigured.
Read more in Pattern WorkHigh on downwind: 1,420 ft against 1,000 ft, 420 ft above.
Downwind. Parallel to the runway, opposite the landing direction, at pattern altitude and roughly 90 kt. The single most important moment of the entire circuit is the point abeam your intended touchdown point. Power back (around 1,700 RPM in a 172 works as a starting value to calibrate), first stage of flap, pre-landing flow, and re-trim. Everything from abeam to touchdown is one continuous energy problem. Arrive at the abeam point high or fast and you'll pay for it ninety seconds later in the flare, which is why analysing only the touchdown so often misdiagnoses the fault.
Read more in Pattern WorkGood: full marks on the turn and the leg after it.
Good: full marks on the turn.
The final from 4 nm.
Profile height against the 3° glideslope, with its 1° band in green.
Inside the glideslope band from 2.5 nm, where the final began, to the threshold, never more than 70 ft below the slope.
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 305 m past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 386 m left of the centreline at 2.5 nm, then inside it from 2.1 to 0.8 nm, then 35 m left of it from 0.8 nm to the threshold.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 20 kt fast at the 1,000 ft gate, closing to 12 at 500 ft and 10 at the threshold.
Inside the speed band all the way, between +2 kt and +15 kt on the approach speed of 80 kt.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
The flare wandered off the target profile
The aircraft was flown onto the runway - pitch changed 1.3° and the descent was barely arrested. Touchdown was 460 m past the threshold. Start the flare with progressive back pressure rather than one pull, and keep it coming.
Touchdown
Rollout
Taxi in
Side view — the last 1,524 m of the approach.
Crossed the threshold at 50 ft, close to the 50 ft target; began the flare at 20 ft. Touched down 460 m in, 156 m past the ideal 305 m.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 1,524 m across. The dashed line is the ideal, 50 ft over the threshold and down 305 m in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 240 fpm at the flare to 140 fpm at 8 ft, then back up to 320 fpm at touchdown. The nose came up 0.5° on the way down. Into the flare at 81 kt, on the 80 kt approach speed, and 76 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the first 1,524 m of the 3,050 m runway, to the same scale as the side view.
Touched down 9.4 m left of the centreline and drifted to 23 m right on the rollout. Little crosswind (2 kt): nothing to correct for. Touched down with the nose 1° right of the track, 3.1° of bank.
Wind 020° at 6 kt · 6 kt head · 2 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
The 460 m touchdown sits inside the full-score zone. The 1.24 G arrival bounced.
The rest of the report
Scroll or drag the slider to zoom · double-click to reset · hover for values