Events
Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Apply small rudder corrections to track the centreline against a point at the far end of the runway.
What happened: The takeoff roll drifted 9.2 m off the centreline, and a heading variation of -1.5° usually follows into the initial climb.
Watch for: Heading indicator: wings-level runway heading held through the climb
Arrival
Add power on final to keep the approach speed at 66 kt rather than letting it decay before the threshold.
What happened: The aircraft crossed the threshold at 57 kt, 9 kt below the target, and touchdown followed with a firm, high sink rate arrival. Crossing the threshold slow like this usually carries through to a firmer touchdown as the flare runs out of energy.
Watch for: Airspeed indicator: 66 kt at the threshold.
Bank angle in the pattern is conventionally kept to 20 to 30 degrees, and the base-to-final turn is where that convention earns its keep. Stall speed rises with bank because the wing must produce more lift in a turn. Roughly 7 per cent higher at 30 degrees, about 19 per cent at 45, and around 40 per cent at 60. At 65 kt on base you don't have much margin to spend steepening a turn to salvage an overshoot.
Read more in Pattern WorkStart to finish · 16 stages, 14 in the score
Events
Events
Events
Events
Events
Events
Taxi out
The roll
Rotated early
Rotation started at 62 kt, 6 kt before the 68 kt rotate speed.
The rotate speed is set for the weight and the flap, and the nose should not start up before it. Lifting it early brings the aircraft to its liftoff attitude with less speed in hand, and on a long fuselage that is the tail-strike case. Keep the hands still until the speed is there, then make one smooth, continuous pull.
Liftoff and climb
Plan view the roll down the 513 m runway.
Rolled from 28 m in, drifted left of the centreline, 8.8 m at the widest, and lifted off 8.9 m left. Airborne 71 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length.
Side view from the start of the roll to 265 ft. The distance scale changes past the runway end.
Reached 35 ft 49 m past the runway end; then climbing at 720 fpm on average to 265 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length. The dark stretch of the roll is the run with the nose up and the wheels still on, with its length and time under the runway.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The dashed green line is the speed to rotate at for this aircraft at its weight, and the green dot is where the nose started to come up. The grey band is the run between the nose coming up and the wheels leaving the runway. The figures at liftoff are the pitch then and how fast the nose came up, in degrees a second. The grey dashed line across the pitch is the attitude held from 35 ft to the end: a nose held steady is a climb speed that holds, and the airspeed trace sits directly above it to compare.
Left-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 1.4 nm out at 143 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Off heading: 12° from the leg's heading on average.
Each lap slightly wider and higher than the last, because you're unconsciously using the previous lap as your reference instead of the runway and the numbers. Invisible lap to lap, unmistakable across ten. This is the failure that only measurement catches, because your memory of lap three is gone by lap eight.
Read more in Pattern WorkSteep: 48° of bank.
Bank angle in the pattern is conventionally kept to 20 to 30 degrees, and the base-to-final turn is where that convention earns its keep. Stall speed rises with bank because the wing must produce more lift in a turn. Roughly 7 per cent higher at 30 degrees, about 19 per cent at 45, and around 40 per cent at 60. At 65 kt on base you don't have much margin to spend steepening a turn to salvage an overshoot.
Read more in Pattern WorkOff heading: 12° from the leg's heading on average.
Overshot: went 161 m through the centreline turning final.
Overshooting final. A tailwind component on base sweeps you through the extended centreline, the instinctive correction is to steepen the bank and, when that's not enough, to skid the turn with rudder. In a real aircraft this is the base-to-final stall-spin scenario that kills people. The sim under-punishes it, because a spring yoke transmits no lightening of control force, there's no buffet through your hands, and no seat-of-the-pants sensation of the skid. You get the numbers of the skidded turn without the feel of it. The correct response is the same in both worlds and needs practising until it's reflexive. Don't steepen past 30 degrees, and if you've blown through the centreline, go around and reset.
Read more in Pattern WorkThe final from 4 nm.
Profile height against the 3° glideslope, with its 2° band in green.
Inside the glideslope band from 1.4 nm, where the final began, to the threshold, never more than 320 ft above the slope.
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 305 m past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 161 m right of the centreline at 1.4 nm.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 33 kt fast at the 1,000 ft gate, closing to 20 at 500 ft and 10 at the threshold.
Fast from 1.4 nm, where the final began, to 0.7 nm (up to +45 kt), then inside the band to the threshold.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
Perfect landing flare
Touchdown
Rollout
Side view — the last 513 m of the approach.
Began the flare at 27 ft, 43 m before the threshold; crossed the threshold at 13 ft, 37 ft below the 50 ft target. Touched down 93 m in, 212 m short of the ideal 305 m.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 513 m across. The dashed line is the ideal, 50 ft over the threshold and down 305 m in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 1,970 fpm at the flare to 340 fpm at touchdown. The nose came up 5.2° on the way down. Into the flare at 60 kt, 6 kt under the 66 kt approach speed, and 50 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the full 513 m runway, to the same scale as the side view.
Touched down on the centreline and drifted to 4.6 m right on the rollout. No crosswind: nothing to correct for. Touched down straight, 2.5° of bank.
Wind 270° at 1 kt · 0 kt head · 0 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
The 93 m touchdown sits inside the full-score zone. The 1.71 G arrival is the firm side of smooth.
The stop — touchdown to taxi speed.
From 57 kt at touchdown to taxi speed (30 kt) in 7 s, an average deceleration of 0.21 g.
Your ground speed from the moment the wheels touched until you were down to taxi speed, against the distance rolled. A steep line is hard braking, a shallow one a long, gentle roll. For scale, an airliner's lowest autobrake setting decelerates at about 0.15 g, a medium one about 0.3 g. Shown for reading; not marked.
The rest of the report
The Kodiak 100 taxied from the parking area to runway 19 at AYPB Paiela Airport in a period of 4 minutes, covering less than 1 nm.
During the departure roll on runway 19, the aircraft used 380 m of runway, representing 74 % of the available length, and achieved liftoff at 66 kt. Ambient conditions were 16 °C with a wind of 1 kt from 270°, a cross-wind component of 1 kt and no head-wind.
Climb commenced overhead AYPB Paiela Airport, Porgera (Morobe Province, Papua New Guinea), with the aircraft ascending from 6,479 ft asl to 7,218 ft asl, a gain of 739 ft achieved in 2 minutes while covering 3 nm.
Descent began 2 miles east of AYPB Paiela Airport, Porgera (Morobe Province, Papua New Guinea), with a reduction from 7,195 ft asl to 6,452 ft asl, a loss of 743 ft over 2 minutes and a distance of 4 nm.
The aircraft landed on runway 19 at AYPB Paiela Airport, whose length is 513 m. The threshold speed was recorded at 57 kt, slightly below the target, and touchdown occurred 91 m down the runway at 50 kt with a descent rate of minus 160 fpm; runway alignment at touchdown was perfect. Weather at the time was 15 °C with a wind of 1 kt from 270°, a cross-wind of 1 kt and no head-wind.
Rollout distance measured 243 m, representing 47 % of the runway, and the aircraft maintained perfect alignment throughout the rollout.
In total, the flight covered 8 nm, required 7 minutes of airborne time, and consumed 29 kg of fuel.
Scroll or drag the slider to zoom · double-click to reset · hover for values