Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Hold the nose down until the speed reaches 78 kt, then rotate.
What happened: You started the rotation at 66 kt, 12 kt before the 78 kt rotation speed.
Watch for: Airspeed indicator: 78 kt at rotation
See Departure Roll
Arrival
Fly a steeper descent on final so you cross the threshold at 50 ft.
What happened: You crossed the threshold at 77 ft agl, above the 50 ft agl target. Crossing high like this usually reduces your margin before the touchdown zone ends.
Watch for: Radio altimeter against 50 ft at the threshold.
See Arrival Landing
A typical trainer rotates in the mid-50s of knots - a 172 at around 55 KIAS, climbing out at a Vy in the low 70s, though check your own POH rather than memorising Cessna's numbers - and the transferable rule is that Vr sits just above the stall speed in takeoff configuration. Rotate early because "it felt ready" and the aircraft lifts off inside ground effect, where induced drag is reduced, then climbs out of it into more drag. On a marginal-performance day the result is an aircraft that lifts off and then refuses to climb, sagging back towards the runway.
Read more in Improve Your Take-OffsStart to finish · 17 stages, 14 in the score
Events
Events
Events
Events
Events
Taxi out
The roll
Rotated early
Rotation started at 66 kt, 12 kt before the 78 kt rotate speed.
The rotate speed is set for the weight and the flap, and the nose should not start up before it. Lifting it early brings the aircraft to its liftoff attitude with less speed in hand, and on a long fuselage that is the tail-strike case. Keep the hands still until the speed is there, then make one smooth, continuous pull.
Liftoff and climb
Plan view the roll down the 3,518 ft runway.
Rolled from 1,467 ft in, drifted 21 ft left of the centreline and was back on it to lift off, in 13 kn of crosswind from the left. Airborne 74 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way.
Side view from the start of the roll to 134 ft.
Reached 35 ft with 465 ft of runway left; then climbing at 610 fpm on average to 134 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length. The dark stretch of the roll is the run with the nose up and the wheels still on, with its length and time under the runway.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The dashed green line is the speed to rotate at for this aircraft at its weight, and the green dot is where the nose started to come up. The grey band is the run between the nose coming up and the wheels leaving the runway. The figure at liftoff is the pitch then. The grey dashed line across the pitch is the attitude held from 35 ft to the end: a nose held steady is a climb speed that holds, and the airspeed trace sits directly above it to compare.
Left-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 1.2 nm out at 119 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Early: turned crosswind at 622 ft. US guidance is within 300 ft of circuit height, 700 ft here, so the climb ends on downwind.
Crosswind. Turn 90 degrees when you're within about 300 ft of pattern altitude, which at a standard field means roughly 700 ft AGL, or two-thirds of the way up. That rule exists for a reason worth knowing. It means you finish the climb and level off on downwind, wings level, rather than trying to capture an altitude mid-turn. If you turn crosswind at pattern altitude instead, you arrive on downwind still cleaning up, and the abeam point catches you unconfigured.
Read more in Pattern WorkHigh on downwind: 1,127 ft against 1,000 ft, 127 ft above.
Downwind. Parallel to the runway, opposite the landing direction, at pattern altitude and roughly 90 kt. The single most important moment of the entire circuit is the point abeam your intended touchdown point. Power back (around 1,700 RPM in a 172 works as a starting value to calibrate), first stage of flap, pre-landing flow, and re-trim. Everything from abeam to touchdown is one continuous energy problem. Arrive at the abeam point high or fast and you'll pay for it ninety seconds later in the flare, which is why analysing only the touchdown so often misdiagnoses the fault.
Read more in Pattern WorkLate: turned base with the threshold 25° behind, against 45°.
The stopwatch. From abeam the threshold, fly roughly 30 to 45 seconds before turning base, in nil wind at 172 speeds. Treat that as a starting value and calibrate it. If your finals keep coming out at 400 ft instead of 500, add a few seconds. Then adjust for wind, roughly a second per knot of headwind on final (a headwind on final is a tailwind on downwind, carrying you further from the field per second).
Read more in Pattern WorkGood: full marks on the turn.
The final from 4 nm.
Profile height against the 3° glideslope, with its 2° band in green.
On the glideslope from 2.0 nm, where the final began, to 0.6 nm, then high to the threshold (up to 150 ft over).
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 1,000 ft past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 1,950 ft left of the centreline at 2.0 nm, then inside the band from 1.3 nm to the threshold.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 39 kt fast at the 1,000 ft gate, closing to 23 at 500 ft and 10 at the threshold.
Inside the speed band all the way, between −1 kt and +5 kt on the approach speed of 77 kt.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
The flare tracked the target profile exactly
The flare was flown from 77 ft agl over the threshold, well above the target height, so the aircraft was above the profile for most of the landing. Touchdown was 1,304 ft past the threshold. The flare cannot recover height that was never lost - fly the approach down to the aim point and the flare has somewhere to start from.
Touchdown
Rollout
Side view — the last 3,518 ft of the approach.
Crossed the threshold at 77 ft, 27 ft above the 50 ft target; began the flare at 20 ft. Touched down 1,304 ft in, 304 ft past the ideal 1,000 ft.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 3,518 ft across. The dashed line is the ideal, 50 ft over the threshold and down 1,000 ft in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 590 fpm at the flare to 80 fpm at touchdown. The nose came up 4.7° on the way down. Into the flare at 74 kt, 3 kt under the 77 kt approach speed, and 64 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the full 3,518 ft runway, to the same scale as the side view.
Touched down 6 ft right of the centreline, and stayed within 6 ft of it down the rollout. 13 kt across from the left, which takes about 12° of crab to hold the centreline at 64 kt. Touched down with 11° of it still on, wings level.
Wind 263° at 14 kt · 3 kt tail · 13 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
The 1,304 ft touchdown sits inside the full-score zone. The arrival was smooth.
The stop — touchdown to taxi speed.
From 69 kt at touchdown to taxi speed (30 kt) in 12 s, an average deceleration of 0.19 g.
Your ground speed from the moment the wheels touched until you were down to taxi speed, against the distance rolled. A steep line is hard braking, a shallow one a long, gentle roll. For scale, an airliner's lowest autobrake setting decelerates at about 0.15 g, a medium one about 0.3 g. Shown for reading; not marked.
The rest of the report
Scroll or drag the slider to zoom · double-click to reset · hover for values