Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Start bringing the nose up as the speed reaches 54 kt, not after it.
What happened: You started the rotation at 70 kt, 16 kt past the 54 kt rotation speed.
Watch for: Airspeed indicator: 54 kt at rotation
See Departure Roll
Arrival
Add power on short final to hold 60 kt at the threshold rather than letting speed decay.
What happened: You crossed the threshold at 47 kt against a target of 60 kt, below reference speed.
Watch for: Airspeed indicator, hold 60 kt down to the threshold.
See Arrival Landing
A typical trainer rotates in the mid-50s of knots - a 172 at around 55 KIAS, climbing out at a Vy in the low 70s, though check your own POH rather than memorising Cessna's numbers - and the transferable rule is that Vr sits just above the stall speed in takeoff configuration. Rotate early because "it felt ready" and the aircraft lifts off inside ground effect, where induced drag is reduced, then climbs out of it into more drag. On a marginal-performance day the result is an aircraft that lifts off and then refuses to climb, sagging back towards the runway.
Read more in Improve Your Take-OffsStart to finish · 12 stages, 12 in the score
Events
Events
Events
Taxi out
The roll
Rotated late
Rotation started at 70 kt, 16 kt after the 54 kt rotate speed.
The pull started after the rotate speed had gone by. Bring the airspeed into the scan as it approaches the rotate speed, so the pull starts on the number rather than when you notice it has passed.
Liftoff and climb
Plan view the roll down the 1,636 m runway.
Rolled from 405 m in, drifted right of the centreline, 1.7 m at the widest, and lifted off 1.3 m left. Airborne 30 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length.
Side view from the start of the roll to 388 ft.
Reached 35 ft with 783 m of runway left; then climbing at 720 fpm on average to 388 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The figure at liftoff is the pitch then.
Left-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 0.8 nm out at 79 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Good: full marks on the turn and the leg after it.
Low on downwind: 764 ft against 1,000 ft, 236 ft below.
Descending on downwind. Power comes back abeam, the aircraft isn't re-trimmed, your eyes are outside judging the turn point, and 100 ft leaks away before base. Shows up as a low gate 2, and everything after it is a scramble.
Read more in Pattern WorkGood: full marks on the turn and the leg after it.
Good: full marks on the turn.
The final from 4 nm.
Profile height against the 3° glideslope, with its 2° band in green.
Inside the glideslope band from 0.7 nm, where the final began, to the threshold, never more than 80 ft above the slope.
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 305 m past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 215 m left of the centreline at 0.7 nm, then inside the band from 0.4 nm to the threshold.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 30 kt fast at the 1,000 ft gate, closing to 18 at 500 ft and 10 at the threshold.
Inside the speed band all the way, between −13 kt and +8 kt on the approach speed of 60 kt.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
Perfect landing flare
Touchdown
Side view — the last 1,524 m of the approach.
Began the flare at 21 ft, 116 m before the threshold; crossed the threshold at 7 ft, 43 ft below the 50 ft target. Touched down 59 m in, 246 m short of the ideal 305 m.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 1,524 m across. The dashed line is the ideal, 50 ft over the threshold and down 305 m in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 360 fpm at the flare to 100 fpm at touchdown. The nose came up 2.8° on the way down. Into the flare at 52 kt, 8 kt under the 60 kt approach speed, and 45 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the first 1,524 m of the 1,636 m runway, to the same scale as the side view.
Touched down on the centreline. No crosswind: nothing to correct for. Touched down straight, wings level.
Wind 270° at 1 kt · 1 kt head · 0 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
The 59 m touchdown sits inside the full-score zone. The arrival was smooth.
The rest of the report
Scroll or drag the slider to zoom · double-click to reset · hover for values