Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Departure
Use small, coordinated rudder and aileron inputs to hold your assigned climb heading as soon as drift begins.
What happened: During the second climb segment, you let the aircraft drift off the assigned heading.
Watch for: Heading indicator: steady on the assigned climb heading
Arrival
Add power earlier on final to hold VREF of 81 kt by the gates rather than let speed decay.
What happened: The approach was flown too slow through the stabilisation gates, crossing the threshold at 85 kt against a VREF of 81 kt.
Watch for: Airspeed indicator against 81 kt from the first stabilisation gate onward.
See Arrival Approach
Start to finish · 21 stages, 19 scored
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
The threshold, the flare and the hold-off. The approach that led to it is the stabilisation gates below.
Two stabilised approach gates, each with seven checks, where the approach path is 1,000 ft and 500 ft above the runway. They are the approach's score: the checks passed out of the checks that ran.
At the 1,000 ft gate: speed 12 kt SLOW on the reference speed of 81 kt.
The approach, gate by gate
Side view — the last 1,524 m of the approach.
Plan view — the first 1,524 m of the 1,737 m runway, to the same scale as the side view.
The 368 m touchdown sits inside the full-score zone. The arrival was smooth.
The rest of the report
The Diamond DA42 Twin Star taxied to runway 27 at EGBJ Gloucestershire Airport and commenced its departure roll, covering 499 m (43 % of the runway) before lifting off at 83 kt. Ambient conditions were 21 °C with a wind of 13 kt from 210°, including a 10 kt cross-wind component and an 8 kt head-wind component.
The initial climb began overhead the airport, climbing from 786 ft asl to 7,023 ft asl, an altitude gain of 6,236 ft achieved in 5 minutes while traversing 11 nm.
A level cruise segment started 1 nm east of Winchcombe and lasted 5 minutes, during which the aircraft covered 13 nm at a steady altitude.
The next climb segment started overhead Shipston on Stour, rising from 6,606 ft asl to 7,179 ft asl, a gain of 573 ft in 2 minutes over a distance of 3 nm.
A subsequent cruise leg began 1 nm north-east of Lower Brailes, lasting 3 minutes and covering 5 nm.
The following climb commenced 1 nm north-west of Lower Brailes, increasing altitude from 6,747 ft asl to 7,316 ft asl, a rise of 569 ft in 2 minutes while covering 2 nm.
A brief cruise then continued overhead Shipston on Stour for 2 minutes, covering 2 nm at constant altitude.
Descent began 1 nm north-west of Shipston on Stour, descending from 7,525 ft asl to 7,067 ft asl, a loss of 457 ft in 2 minutes across 3 nm.
The aircraft entered another level cruise segment over Halford, lasting 6 minutes and spanning 13 nm.
A further descent started 2 nm north-west of Hornton, dropping from 7,849 ft asl to 3,569 ft asl, a decrease of 4,280 ft in 5 minutes while covering 12 nm.
A long cruise phase followed over EGKV Preston Capes Airfield, lasting 26 minutes and covering 49 nm at a steady altitude.
The final descent commenced overhead Oakley, descending from 2,211 ft asl to 1,399 ft asl, a loss of 812 ft in 2 minutes over 2 nm.
The aircraft entered the final approach to runway 21 at EGTC Cranfield Airport from the north-east, aligned on a heading of 210.0° at 4 nm and 1,014 ft agl.
Landing on runway 21, which is 1,737 m long, the aircraft touched down after 367 m with a speed of 60 kt and a vertical rate of minus 176 fpm; the touchdown point was 3.3 m off centreline. The threshold speed was recorded at 85 kt, and the total landing roll measured 617 m (36 % of the runway). Weather at the time was 21 °C with a wind of 15 kt from 190°, a 5 kt cross-wind component and a 14 kt head-wind component. Runway rollout alignment was judged very good.
In total the flight covered 120 nm, required 64 minutes of elapsed time, and consumed 30 kg of fuel.
Scroll or drag the slider to zoom · double-click to reset · hover for values