Events
Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Arrival
Level off earlier after the climb-out, using a timely power reduction to join downwind at the correct circuit altitude.
What happened: The downwind leg was flown high, at 1,402 ft agl against the published circuit altitude.
Watch for: Altimeter: the published circuit altitude throughout the downwind leg.
See Pattern Downwind
Downwind. Parallel to the runway, opposite the landing direction, at pattern altitude and roughly 90 kt. The single most important moment of the entire circuit is the point abeam your intended touchdown point. Power back (around 1,700 RPM in a 172 works as a starting value to calibrate), first stage of flap, pre-landing flow, and re-trim. Everything from abeam to touchdown is one continuous energy problem. Arrive at the abeam point high or fast and you'll pay for it ninety seconds later in the flare, which is why analysing only the touchdown so often misdiagnoses the fault.
Read more in Pattern WorkStart to finish · 16 stages, 13 in the score
Events
Events
Events
Events
Events
Events
From brake release to the end of the climb, against time, then the takeoff point by point.
Rotated at 84 kt, 3 kt above the 81 kt target, and lifted off at 86 kt 0.6 s later, the nose coming up at 2.2° a second.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The dashed green line is the speed to rotate at for this aircraft at its weight, and the green dot is where the nose started to come up. The figures at liftoff are the pitch then and how fast the nose came up, in degrees a second.
The takeoff, point by point
Side view from the start of the roll to 1,372 ft.
Reached 35 ft with 1,579 m of runway left; then climbing at 1,160 fpm on average to 1,372 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length.
Plan view the roll down the 2,490 m runway.
Rolled from 138 m in, drifted 1.8 m left of the centreline and was back on it to lift off. Airborne 26 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way.
Left-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 1 nm out at 97 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Good: full marks on the turn and the leg after it.
High on downwind: 1,402 ft against 1,000 ft, 402 ft above.
Downwind. Parallel to the runway, opposite the landing direction, at pattern altitude and roughly 90 kt. The single most important moment of the entire circuit is the point abeam your intended touchdown point. Power back (around 1,700 RPM in a 172 works as a starting value to calibrate), first stage of flap, pre-landing flow, and re-trim. Everything from abeam to touchdown is one continuous energy problem. Arrive at the abeam point high or fast and you'll pay for it ninety seconds later in the flare, which is why analysing only the touchdown so often misdiagnoses the fault.
Read more in Pattern WorkOff heading: 11° from the leg's heading on average.
Bank angle in the pattern is conventionally kept to 20 to 30 degrees, and the base-to-final turn is where that convention earns its keep. Stall speed rises with bank because the wing must produce more lift in a turn. Roughly 7 per cent higher at 30 degrees, about 19 per cent at 45, and around 40 per cent at 60. At 65 kt on base you don't have much margin to spend steepening a turn to salvage an overshoot.
Read more in Pattern WorkGood: full marks on the turn.
The final from 4 nm.
Profile height against the 3° glideslope, with its 2° band in green.
Inside the glideslope band from 1.2 nm, where the final began, to the threshold, never more than 20 ft above the slope.
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 305 m past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 290 m left of the centreline at 1.2 nm, then inside the band from 1.0 nm to the threshold.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 41 kt fast at the 1,000 ft gate, closing to 25 at 500 ft and 10 at the threshold.
Inside the speed band all the way, between −2 kt and +5 kt on the approach speed of 82 kt.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
Perfect landing flare
Touchdown
Rollout
Side view — the last 1,524 m of the approach.
Crossed the threshold at 32 ft, 18 ft below the 50 ft target; began the flare at 24 ft. Touched down 291 m in, close to the ideal 305 m.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 1,524 m across. The dashed line is the ideal, 50 ft over the threshold and down 305 m in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 630 fpm at the flare to 190 fpm at touchdown. The nose came up 7.2° on the way down.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the first 1,524 m of the 2,490 m runway, to the same scale as the side view.
Touched down on the centreline, and stayed within 2 m of it down the rollout. Little crosswind (1 kt): nothing to correct for. Touched down straight, wings level.
Wind 269° at 2 kt · 2 kt head · 1 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The arrow beside the runway is the crosswind, pointing the way the air was moving, so it pushed the aircraft that way. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
The 291 m touchdown sits inside the full-score zone. The arrival was smooth.
The stop — touchdown to taxi speed.
From 61 kt at touchdown to taxi speed (30 kt) in 7 s, an average deceleration of 0.23 g.
Your ground speed from the moment the wheels touched until you were down to taxi speed, against the distance rolled. A steep line is hard braking, a shallow one a long, gentle roll. For scale, an airliner's lowest autobrake setting decelerates at about 0.15 g, a medium one about 0.3 g. Shown for reading; not marked.
The rest of the report
The Diamond DA42 Twin Star taxied to runway 23 at EHGG Groningen Airport Eelde and commenced the take-off roll. The aircraft used 671 m of runway, representing 27 % of the available length, and became airborne at a liftoff speed of 86 kt. Ambient conditions were 16 °C with a wind of 2 kt from 270°, a cross-component of 1 kt and a head-wind component of 2 kt.
During the climb the aircraft passed overhead Donderen in the province of Drenthe, ascending from 1,002 ft asl to 1,559 ft asl. The altitude gain of 557 ft was achieved in 2 minutes while covering 3 nm.
The subsequent level cruise also began over Donderen and persisted for 2 minutes, during which the aircraft travelled another 3 nm at a constant altitude.
Descent commenced one mile south-west of Noordlaren in the province of Groningen, with the aircraft descending from 1,207 ft asl to 292 ft asl. This loss of 915 ft occurred over 2 minutes and spanned 2 nm.
On final approach to runway 23 the aircraft reduced altitude from 428 ft agl to 49 ft agl in 48 seconds and met the stabilisation gate criteria.
Landing was executed on runway 23, whose total length is 2,490 m. The threshold height was satisfactory and the threshold speed was slightly below the target at 80 kt. Touchdown occurred 289 m down the runway at a speed of 60 kt with a vertical speed of minus 190 fpm, and the aircraft aligned perfectly with the centreline. Weather at the time was 15 °C with a wind of 2 kt from 269°, a cross-component of 1 kt and a head-wind component of 2 kt.
The rollout covered a total landing distance of 437 m, equivalent to 18 % of the runway, and the alignment remained perfect throughout the deceleration phase.
In total the flight covered 11 nm, taking 6 (units as provided) and consumed 3 kg of fuel.
Scroll or drag the slider to zoom · double-click to reset · hover for values