Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Arrival
Add power and raise the nose to climb back to pattern altitude on downwind before continuing the circuit.
What happened: On downwind the circuit height was low at 795 ft agl.
Watch for: Altimeter: hold the normal downwind circuit height
See Pattern Downwind
A small uncorrected heading error at 40 knots becomes a metre of offset per second by 100 knots, noticed only at rotation, producing a crabbed liftoff. Root cause is nearly always eyes on the tape instead of the far end of the runway. Small heading changes displace a distant point visibly long before the nearby centreline stripes look wrong.
Read more in Improve Your Take-OffsStart to finish · 15 stages, 13 in the score
Events
Events
Events
Events
Events
Taxi out
The roll
A clean takeoff
Rotated at 62 kt against the 59 kt rotate speed, the nose rising at 1.7° a second, then held 4.6° from 35 ft, within 2.9° top to bottom.
Rotated on speed at a steady rate, and the climb attitude held. This is the takeoff to repeat: the same speed check, the same pull, the same attitude.
Liftoff and climb
Plan view the roll down the 4,390 ft runway.
Rolled from 542 ft in, drifted left of the centreline, 13 ft at the widest, and lifted off 13 ft left. Airborne 23 % of the way down the runway, before the 75 % line.
The roll from above, with your left at the top. The line is where the wheels went, and "widest" is the furthest you drifted off the centreline. Lifting off before the amber 75 % line gets full marks for the roll length.
Side view from the start of the roll to 210 ft.
Reached 35 ft with 2,719 ft of runway left; then climbing at 540 fpm on average to 210 ft.
The takeoff from the side: the height above the runway against the distance along it. The numbers along the runway are the speeds reached at each point. Lifting off in the amber last quarter of the runway costs marks for the roll length. The dark stretch of the roll is the run with the nose up and the wheels still on, with its length and time under the runway.
Speed and pitch from brake release to the end of the climb, against time.
Two traces from brake release: the airspeed on top, and below it the pitch, which is how far the nose is above the horizon. The dashed green line is the speed to rotate at for this aircraft at its weight, and the green dot is where the nose started to come up. The grey band is the run between the nose coming up and the wheels leaving the runway. The figures at liftoff are the pitch then and how fast the nose came up, in degrees a second. The grey dashed line across the pitch is the attitude held from 35 ft to the end: a nose held steady is a climb speed that holds, and the airspeed trace sits directly above it to compare.
Left-hand, 1,000 ft circuit height. The plan shows your circuit over a textbook one for this runway; the profile unrolls the same path from liftoff to the threshold.
Plan landing direction to the left; in pale blue the textbook circuit for your downwind speed, 1.1 nm out at 114 kt
The lap from above, with the landing direction to the left: the opposite of the runway drawings. The wide pale-blue line is a textbook circuit for your downwind speed - the downwind a mile out for every 100 kt, every turn at 30° of bank - and your track is drawn over it, each leg in the colour of its mark. The numbers are the four turns, the same as on the profile and the cards below. The 45° line from the threshold is the usual point to turn onto base.
Around the circuit height and bank; the turns are shaded
The same lap straightened out, so the height and the bank can be read together. Each shaded stretch is a turn, numbered as on the plan. The green box is circuit height, 1,000 ft, on the downwind. The amber line is 30° of bank, and a turn's steepest bank shows red above 32°. "Turn crosswind from" is the lowest height to start the first turn at.
Early: turned crosswind at 298 ft. US guidance is within 300 ft of circuit height, 700 ft here, so the climb ends on downwind.
Crosswind. Turn 90 degrees when you're within about 300 ft of pattern altitude, which at a standard field means roughly 700 ft AGL, or two-thirds of the way up. That rule exists for a reason worth knowing. It means you finish the climb and level off on downwind, wings level, rather than trying to capture an altitude mid-turn. If you turn crosswind at pattern altitude instead, you arrive on downwind still cleaning up, and the abeam point catches you unconfigured.
Read more in Pattern WorkLow on downwind: 795 ft against 1,000 ft, 205 ft below.
Descending on downwind. Power comes back abeam, the aircraft isn't re-trimmed, your eyes are outside judging the turn point, and 100 ft leaks away before base. Shows up as a low gate 2, and everything after it is a scramble.
Read more in Pattern WorkGood: full marks on the turn and the leg after it.
Good: full marks on the turn.
The final from 4 nm.
Profile height against the 3° glideslope, with its 2° band in green.
Inside the glideslope band from 1.2 nm, where the final began, to the threshold, never more than 120 ft above the slope.
Your height above the runway against the distance still to go. The glideslope is the steady descent path to the aiming point, 1,000 ft past the threshold: 3° here, which is about 320 ft for every nautical mile out, crossing the threshold at about 50 ft. The row under the distances is the height it puts you at. Inside the green band your path is drawn green; outside it, amber.
Plan distance off the extended centreline, your left at the top, with the 1° band. Sideways distances are drawn 3× larger than distances along the final.
Joined 810 ft left of the centreline at 1.2 nm, then inside the band from 0.9 nm to the threshold.
Looking down from above, flying left to right towards the runway: up the page is left of the centreline, down is right. Sideways distances are stretched so that small drifts show, so a line that looks wild here may be only a few tens of feet. The labels are how far off you were at each distance, amber when outside the band.
Speed against the approach speed. The green band runs from 5 kt slow to 31 kt fast at the 1,000 ft gate, closing to 19 at 500 ft and 10 at the threshold.
Fast from 1.2 nm, where the final began, to 0.4 nm (up to +47 kt), then inside the band to the threshold.
Your indicated airspeed down the final, against the approach speed for this aircraft at its landing weight. The band allows 5 kt slow and more on the fast side further out, closing as you get lower, because the speed is expected to come off on the way down. The figures are knots above (+) or below (−) the approach speed.
Over the threshold
Perfect landing flare
Touchdown
Rollout
Side view — the last 4,390 ft of the approach.
Began the flare at 23 ft, 208 ft before the threshold; crossed the threshold at 10 ft, 40 ft below the 50 ft target. Touched down 492 ft in, 508 ft short of the ideal 1,000 ft.
The last stretch of the approach and the touchdown, from the side. The height is stretched so that the last few feet show: 80 ft top to bottom, against 4,390 ft across. The dashed line is the ideal, 50 ft over the threshold and down 1,000 ft in. The flare ring is where you began raising the nose, and "descent slowed" is where the sink came off; the figures beside them are the sink rate, pitch and speed at that point.
Sink and pitch — through the flare, lined up with the side view.
The sink went from 520 fpm at the flare to 80 fpm at touchdown. The nose came up 5.0° on the way down. Into the flare at 60 kt, on the 62 kt approach speed, and 51 kt at touchdown.
Lined up with the side view above, so a point on one sits under the same point of the other. On top, how fast you were coming down: 0 is level, and −600 is 600 ft a minute down. Below, the pitch. In a flare the nose comes up and the descent slows towards 0. The figure at the touchdown line is your touchdown rate.
Plan view — the full 4,390 ft runway, to the same scale as the side view.
Touched down 6 ft right of the centreline, and stayed within 7 ft of it down the rollout. No crosswind: nothing to correct for. Touched down with the nose 1° left of the track, wings level.
Wind 270° at 1 kt · 0 kt tail · 0 kt across
The runway from above, with your left at the top. Touching down inside the green bracket scores full marks for the distance. The shaded part is the rollout, up to where it ended. The wind is the one recorded at the landing, split along the runway (headwind or tailwind) and across it. To hold the centreline in a crosswind the nose points a little into wind - the crab - and is straightened with rudder just before the wheels touch, often with the into-wind wing lowered to stop the drift. The sentence gives the nose against the direction you were actually moving as the wheels touched, and the steepest bank as they touched, the figure the touchdown's Bank tile marks. The rest of it is shown for reading, not marked.
The 492 ft touchdown sits inside the full-score zone. The arrival was smooth.
The stop — touchdown to taxi speed.
From 52 kt at touchdown to taxi speed (30 kt) in 8 s, an average deceleration of 0.14 g.
Your ground speed from the moment the wheels touched until you were down to taxi speed, against the distance rolled. A steep line is hard braking, a shallow one a long, gentle roll. For scale, an airliner's lowest autobrake setting decelerates at about 0.15 g, a medium one about 0.3 g. Shown for reading; not marked.
The rest of the report
Scroll or drag the slider to zoom · double-click to reset · hover for values