Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
MY FS FLIGHTS
Flight Score
Slow the descent speed
Below 10,000 ft you are typically limited to 250 kt indicated (a US rule that much of the world mirrors in some form, though not universally). This forces a deceleration around 10,000 ft whether the profile wants one or not, so plan for it rather than discovering it.
Read more in Descent PlanningStart to finish · 22 stages, 20 scored
Events
Events
Events
Events
Events
Events
Events
Events
Events
Events
Two stabilised approach gates, each with five checks, where the approach path is 1,000 ft and 500 ft above the runway.
The approach, gate by gate
Side view — the last 1,524 m of the approach.
Plan view — the first 1,524 m of the 2,739 m runway, to the same scale as the side view.
The 454 m touchdown sits inside the full-score zone. The arrival was smooth.
The rest of the report
The Airbus A319 taxied from the parking area to runway 22L at KMDW Chicago Midway International Airport, covering 1 nm in 5 minutes.
During the departure roll on runway 22L, the aircraft used 985 m of runway, representing 56 % of the available length, and lifted off at 134 kt. Local conditions were a temperature of 31 °C, wind 7 kt from 240°, with a 2 kt cross-wind component and a 7 kt head-wind.
Climb commenced 1 mile east of Bedford Park, Illinois, where the A319 rose from 1,406 ft asl to 38,008 ft asl, an altitude gain of 36,602 ft achieved in 16 minutes while covering 149 nm.
The first cruise segment began 4 miles southeast of Martinsville, Illinois, lasting 3 minutes and traversing 79 nm.
A descent started overhead 03II Davis Field Ultralightport, Indiana, dropping from 38,013 ft asl to 37,010 ft asl, a loss of 1,003 ft in 2 minutes over 21 nm.
The next cruise phase originated 1 mile southwest of Sebree, Kentucky, continued for 5 minutes and covered 145 nm.
A subsequent descent began 4 miles north of Tullahoma, Tennessee, descending from 37,018 ft asl to 5,013 ft asl, a reduction of 32,004 ft in 17 minutes while traveling 156 nm.
A brief cruise followed 2 miles southeast of Lithonia, Georgia, lasting 2 minutes and spanning 5 nm.
The final descent started 3 miles northwest of 8GA0 Pinetree Heliport, Cumming, Georgia, decreasing altitude from 4,452 ft asl to 2,305 ft asl, a loss of 2,148 ft in 2 minutes across 7 nm.
The aircraft entered the final approach to runway 26R at KATL Hartsfield-Jackson Atlanta International Airport from the east, on a heading of 270.0°, at 4 nm and 1,277 ft agl.
Landing on runway 26R, which is 2,739 m long, the threshold speed was 130 kt. Touchdown occurred 453 m down the runway at 125 kt, with a touchdown rate of minus 168 fpm and very good alignment. Weather at the time was 31 °C, wind 11 kt from 300°, with a 5 kt cross-wind and a 9 kt head-wind.
The rollout covered a total landing distance of 1,427 m, equivalent to 52 % of the runway, and the runway-rollout alignment was perfect.
After landing, the Airbus A319 taxied from the runway to the parking area, covering 1 nm in 5 minutes.
In total, the flight covered 571 nm, required 58 minutes of flight time, and consumed 3,743 kg of fuel.
The Airbus A319 established the final approach to runway 26R at KATL from the east, tracking a heading of 270.0° at 4 nm and 1,277 ft AGL while the local temperature was 31 °C, wind 11 kt from 300°, with a 5 kt crosswind component and a 9 kt headwind component.
At threshold the aircraft presented a good threshold height and a good threshold speed of 130 kt on a runway 2,739 m long.
Touchdown occurred 453 m down the runway at a speed of 125 kt, noted as a little fast, with a good touchdown rate of minus 168 fpm and a very good runway touchdown alignment; the total landing distance measured 1,427 m, representing 52 % of the available runway.
The rollout proceeded with perfect runway alignment throughout the remaining distance.
Reduce the touchdown speed by a few knots to bring it within the optimal range, and continue to monitor speed during the flare to maintain the high overall score.
Scroll or drag the slider to zoom · double-click to reset · hover for values